Block MHF-900 Solo, Руководство пользователя

Страница: 45 / 62

45
The amplifier
The MHF-900 Solo is equipped with a high-quality D class amplifier with an output of 2 x 40 watts to 4 ohms
(RMS).
To change the sound, use the following settings:
Volume:
Use „VOL +“ and „VOL-“ buttons on the remote control or the multi-function knob on the device to change the
volume of your system overall.
Please note that for different signal sources, the volume of the MHF-900 Solo can vary with the volume setting.
This is not a defect but it is caused by different input levels of the signal sources.
Balance:
Use the keys „L“ and „R“ on the remote control to change the balance between the two speakers and move to
centralise the sound in the room.
Ton:
To raise or lower the bass, press „Tone“ on the remote control until „Bass“ appears on the display. Use the „VOL
+“ and „VOL-“ buttons on the remote control. This function deactivates after a short time
Press „Tone“ on the remote control so often, until „Treble“ appears in the display. Now press the „VOL +“ and
„VOL-“ buttons on the remote control to increase or decrease the volume. This function deactivates itself after
a short time.
DSP-setting (Digital Sound Processing):
Press the „EQ“ button
This key, is used to switch on various digital sound enhancements such as „Normal“, “Live”, „Jazz“, „Rock“,
„Hall“, „Classic“, „Pop“ and „Stadium“, press several times to view the different modes. Try to find out which
setting suits you best, on the „Normal“ mode this function is deactivated.