Block MHF-900 Solo, Руководство пользователя

Страница: 43 / 62

43
First commissioning and installation
After you have safely installed your device and have carried out all the wirings, you can switch on your MHF-900
Solo for the first time. Please hold your password (WEP or WPA) and, if necessary, your network identifier (SSID)
ready for a possible WiFi installation.
▶ Please, confirm the question after starting the equipment assistant wizard with “Yes”, press the arrows
keys of the remote control until “Yes” lights up and confirm with the key “Enter”
▶ Select your desired time format, either 12 h or 24 h display and confirm with the key „Enter“.
▶ Select in the next step „Update from NET“ (recommended) and confirm.
▶ Every time it starts, your MHF-900 Solo, will in future recover automatically from this source the informa-
tion time and datum.
▶ For the following time zone setting, please select for Germany UTC +1: 00. For other locations, please select
the appropriate time zone and confirm.
▶ In the following setting, please indicate whether your location currently has summer time, then „ON“
would be the correct input
▶ In the following query „Keep network connected?“, it should be confirmed with „Yes“ in order to avoid
interception and streaming problems.
▶ When choosing WiFi region, please choose “Most of Europe”.
▶ Now the MHF-900 Solo starts searching a WiFi connection and shows you all found WiFi networks (SSID)
in your surrounding. Select your WiFi network. In case your WiFi does not appear, this could be due to the
following reasons:
WiFi aerial not installed.
WiFi signal too weak at the installation place (perhaps it would be necessary to adjust the aerial to
the router and on the MHF-900 Solo or use a WLAN repeater).
WiFi SSID suppressed on the router, select the input “Manual configuration”.
If you connect the MHF-900 Solo with an ethernet cable with your router, instead of using WiFi,
select “Cable”.
▶ In case your router supports WPS, select “Press key” and then press the appropriated button on the router.
Alternatively you can also choose “skip WPS” and subsequently enter the network password (WEP or WPA).
Afterwards, in both cases the device should be finally connected.