Blitz GH Series, Инструкция по эксплуатации и список запасных частей

Страница: 10 / 44

Operating Instructions for Suspended Jacks
10
Undercarriages with telescopic carriers
Special castors
C
B A

Insert undercarriage in rails and set track width.

Remove threaded pins A and drill hole B to 8 mm.

Install threaded pins A with thread outwards and tighten.
 Check the secure support of the castors (standard castors min. 25 mm) over the entire length of
the rails.

Adjust and place U profiles C.

Dismantle the tilt protection bracket [1] on the lifting cylinder, insert the lifting cylinder into the
undercarriage and replace the tilt protection bracket on both sides.
Single-piece undercarriages Two-piece undercarriages
E
 Insert undercarriage via installation opening E
into rails.

Check the secure support of the castors
(standard castors min. 25 mm) over the entire
length of the rails.
 Dismantle the tilt protection bracket [1] on the
lifting cylinder, insert the lifting cylinder into
the undercarriage and replace the tilt
protection bracket on both sides.
 Insert undercarriage components in rails and
firmly connect with enclosed screws.

Check the secure support of the castors
(standard castors min. 25 mm) over the entire
length of the rails.
 Dismantle the tilt protection bracket [1] on the
lifting cylinder, insert the lifting cylinder into
the undercarriage and replace the tilt
protection bracket on both sides.