Blitz GH Series, Инструкция по эксплуатации и список запасных частей

Страница: 15 / 44

Operating Instructions for Suspended Jacks
15
6.4 Lift, lower and transport Loads
DANGER
Risk of death and severe injury due to lifted vehicles
 Always secure lifted vehicles with supporting bridges/A-frames.
 Always use suitable load handling devices.

Apply load handling devices only to horizontal, level and load-bearing load application points
specified by the vehicle manufacturer.
 Operate the lift only when there is no risk for persons.
 Do not exceed the maximum load capacity of the jack,
load handling devices and supporting bridges/trestles.

Load the jack and the load handling device only centered by always having the center of gravity of
the load in the middle.
Safety notes

Climbing onto the jack or load is not permitted.

Always keep the movement range of the jack free.
 Keep the movement range of the load and the load handling device free.
 Only drive on the pit when jack is completely retracted
 The complete lifting of vehicles with one or more jacks is not allowed.

Perform lifting and lowering movements evenly. Watch the load.

Only operate jack in a perfectly safe condition.
 In case of a malfunction, stop the lift immediately and secure it. Have any faults repaired
immediately.
 Do not operate the jack with compressed air that contains condensates or debris.

Cover the piston rod with strongly adhering underbody protective agents or paints when working.

Keep the piston rod and spigots of the load handling device free of sand and dirt.
 Disconnect jack from the compressed air supply after finalizing the work or before longer breaks.
 Remove detachable pump rods after each operation.
CAUTION
Damage to jacks and vehicles due to load handling devices and extended piston rods
 When entering and leaving workshop pits and lifting platforms, piston rods must always be
completely retracted.

There must be sufficient clearance between the load handling device and the vehicle.
Considerable longitudinal forces may occur when lifting vehicle axles

Release the vehicle’s parking brake and put the vehicle in neutral so that the standing wheels can
follow.
Lifting vehicles

Use the jack to slightly lift the vehicle at the load application point.

Check that the vehicle is securely supported and sits firmly.

Lift vehicle to the desired height.
 Secure vehicle against rolling away, e.g. with wheel chocks.
 Secure vehicle with supporting bridges/trestles.
Lowering vehicles

Remove roll-away prevention on the vehicle.
 Slightly lift vehicle with the jack and remove the supporting bridges/trestles.
 Lower the vehicle slowly.

Retract the piston rod [10] completely and make sure that the support plate is on the piston rod.
Transport of vehicle parts
 Position the vehicle part centered on a jack with a suitable gear plate.
 Secure the vehicle part with chains or belts.

Retract piston rod [10] completely and transport the vehicle part.