Charge on.
BlinkCharging.com
Page 8 of 56
5.
PRE-INSTALLATION INSTRUCTIONS
5.1.
Safety and Grounding
5.1.1.1.
Safety Check
CAUTION: DISCONNECT ELECTRICAL POWER PRIOR TO INSTALLING THE
BLINK CHARGING STATION. FAILURE TO DO SO MAY CAUSE PHYSICAL INJURY
OR DAMAGE TO THE ELECTRICAL SYSTEM AND BLINK PRODUCT.
The Blink Product should be installed only by a licensed contractor, and/or a licensed
electrician in accordance with all applicable state, local and national electrical codes
and standards.
Before installing the Blink Product, review this manual carefully and consult with a
licensed contractor, licensed electrician and trained installation expert to ensure
compliance with local building practices, climate conditions, safety standards, and
state and local codes.
Use appropriate protection when connecting to the main power distribution cable. Use
tools as outlined in the “Tools Required for Installation” section.
5.1.1.2.
Grounding Instructions
This product must be connected to a grounded, metal, permanent wiring system; and
an equipment grounding conductor must be run with the circuit conductors and
connected to the equipment grounding terminal or lead on the product.
