BrewEasy™ Compact Tri-Clamp V1
© Blichmann Engineering, LLC 2021
For replacement parts, visit: blichmannengineering.com/genuine-replacement-parts
3
Set-Up
Step One:
For electric BrewEasy™ Compact installations, place the kettle on stable, level surface such as the KettleKart™.
For gas BrewEasy™ Compact installations, place the kettle on the burner. Be sure to read the manual for the burner and
follow any setup instructions it may have.
IMPORTANT:
If you are using the Blichmann HellFire™ Burner, it comes configured for LP operation. For use with
natural gas, you will need to install a natural gas conversion kit.
Step Two:
Next, install the dip tube and drain valve on the front of your kettle per the diagram below.
Rotating 1.5” G2 Linear Flow Valve
- Install the rotating valve as shown below. During operation, loosen tri-clamp and rotate
the dip tube to draw from a higher point above any hops or trub.
#
Description
Item #
1
1.5” Clamp
BE-000633-00
2
1.5” Gasket
BE-000868-00
3
Dip Tube O-ring
BE-500386-00
4
Rotating Dip Tube
BE-001686-02
5
1.5” Gasket
BE-000868-00
6
1.5” Clamp
BE-000633-00
7
G2 Tri-Clamp Valve
BE-002055-00
1
2
3
4
5
6
7
The following steps contain assembly procedures for optional accessories that
may not pertain your system.
Step Three:
If you purchased your system with a controller, install the temperature probe into the tri-clamp adapter cap and install
on the back-left tri-clamp port as shown in the exploded view below.
If you purchased your system without a controller, install the included Brewmometer™ in the 1/2” hole in the front of
the kettle.
TEMPERATURE SENSOR ASSEMBLY
Number
Part Number
Description
1
BE-000882-01
Sanitary Nut
2
BE-000882-01
Sanitary Nut Inner Seal
3
BE-000882-01
Sanitary Nut Outer Seal
4
BE-000013-00
Bulkhead O-ring -113
5
BE-001474-00
Weldless Captive Bulkhead
6
BE-001511-00
Captive Nut O-ring
7
BE-001475-00
Captive Nut
8
BE-001500-00
Temperature Sensor Probe
1
2
3
Kettle Wall
with ½” Hole
4 5
6 7
8
To Temperature
Probe Port
Inside Kettle
Outside Kettle
COMPLETE TEMPERATURE SENSOR ASSEMBLY
CAUTION:
• Do not pull sensor by cord, pull by stainless sheath only.
• Do not remove sensor when kettle is full of liquid without
optional thermowell.
