149
EN
GLISH
Press the softkey for the equalizer
(Equalizer 1 – 3) to be calibrated.
Press the "Adjust" softkey
9
.
Press the "Auto L=R" softkey
6
if you
later want to readjust the calibrated
values together for the left and right
channel.
OR:
Press the softkey "Auto L#R"
;
if you
later want to readjust the calibrated val-
ues individually for the left or the right
channel.
The display shows "PLACE MICRO" and
a counter counts down from "5" to "0".
Position the calibration microphone for the
fi rst phase of the calibration.
After the countdown expires, the calibration
is performed. The display alternately shows
"ADJUSTING" and "SILENCE PLEASE!"
After the calibration completes successful-
ly, "ADJUSTMENT OK" is briefl y shown and
you are returned to the menu.
Notes:
If the calibration was not success-
ful, "ADJUSTMENT FAILED – Check
Microphone/Speaker" briefl
y ap-
pears on the display. Repeat the cali-
bration. Check whether the calibra-
tion microphone is connected.
You can repeat the automatic cali-
bration for the equalizer selected
last and with the setting "Auto L=R"
or "Auto L#R" selected last by press-
ing the
MENU
button
A
to open the
menu and then pressing and holding
the "Audio Settings" softkey
6
for
longer than 2 seconds. The automatic
calibration then starts with the count-
쏅
쏅
쏅
쏅
•
•
down. If the equalizer is switched
off, the note "Pls select equalizer" is
briefl y displayed. Next, proceed as
described in this section.
Manually adjusting the equalizer
To manually adjust an equalizer,
press the
MENU
button
A
.
Press the softkey "Audio Settings"
6
.
Press the "DSA" softkey
9
.
The display shows the DSA menu.
Press the "User equalizer" softkey
6
.
Press the softkey for the equalizer
(Equalizer 1 – 3) to be adjusted.
Press the "Adjust" softkey
9
.
Press the "Manual L=R" softkey
7
to
adjust the same values for the left and
the right channel.
OR:
Press the "Manual L#R" softkey
:
to
adjust individual values for the left and
the right channel.
In normal mode, the following setting op-
tions are available depending on the setting
"Manual L=R" or "Manual L#R":
Manual L=R
Manual L#R
Front loudspeakers:
Front EQ
6
Front Left
6
Front Right
7
Rear loudspeakers:
Rear EQ
;
Rear Left
;
Rear Right
:
Centre speaker:
Center
7
Center
8
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
DSA – Digital Sound Adjustment
02_BREMEN_MP78_gb.indd 149
02_BREMEN_MP78_gb.indd 149
04.07.2008 10:17:33 Uhr
04.07.2008 10:17:33 Uhr