20
www.blastrac.eu
Removing the diamond wings
Read chapter 3 Safety first, and wear personal protective equipment.
Lay down the machine so it is laying on the metal support underneath the electrical box. Make sure
the machine will not fall back down. A second person can hold the handle down, to make sure the
machine will not fall back down.
Remove all the dust using the vacuum cleaner.
Grab the diamond wings at the place where the gap in the Diamag plate is and roll the wing over so
the wing can be taken off of the plate. (See picture below)
Mounting the diamond wings
Read chapter 3 Safety first, and wear personal protective equipment.
Lay down the machine so it is laying on the metal support underneath the electrical box. Make sure
the machine will not fall back down. A second person can hold the handle down to make sure the
machine will not fall back down.
Clean the Diamag plates using the vacuum cleaner so the diamond wings will connect well to the
plate.
Dirt between the plates and wings can be the cause of uneven grinding results.
Place the diamond wings one by one on the Diamag plates.
4.7
Before start-up
Before start-up the operating personnel must be familiar with the safety regulations given in this manual.
Put the grinding machine and the dust collector on to the surface to be processed.
Fit the appropriate diamond grinding wings that are required for this particular process. Please read
chapter 4.6 of this manual.
Connect the machine and the dust collector to the electricity supply point, these electric supply points
should be protected and equipped with an earth connection and earth leakage circuit breaker. In case
of doubt ask the local safety officer.
Check the dust hose for damages and obstructions. Make sure the dust bin of the dust collector unit is
empty. Observe the local regulations regarding waste disposal.
Connect the grinding machine and the dust collector unit with the flexible dust hose. Use hose clamps
at the connections.
Before grinding, clean the surface to be treated. There should not be any trash, stones, cloths, or oil
on the surface.
Remove all objects from the surface that can damage the machine. Remove reinforcing steel or other objects
protruding from the surface in order to prevent damage to the machine, the seals or diamond wings.
