1
3
Model BCC905T
INSTALLATION
FIG. 6
A special sealing strip underneath the hob for
damage. Make sure it is correctly positioned with no
gaps; it avoids any water infiltration. To fix in the right
way the strip, please, respect the following
instructions:
- remove all the mobile parts of the hob.
- Cut the seal into 4 strips of the lengths suitable
to fit it along the 4 sides of the glass.
- Overturn the hot plate and correctly position seal
“E” (fig. 6) under the edge of the hot plate itself,
so that the outer side of the seal perfectly
matches the outer perimetral edge of the crystal.
The ends of the strips must fit together without
overlapping.
- Position the hob in the hole in the unit and fasten
it in place using the appropriate screws “F” of the
fastening hooks “G”
(see fig. 7 for model 30
cm., 77 cm. and 90 cm.; fig. 7/A - 7/B for
model 60 cm.).
- In order to avoid accidental contact with the
surface of the box of the overheated hob during
use, it is necessary to install a wooden divider at
a minimum distance of 120 mm from the top,
fastening it in place with screws (fig. 4).
- To fasten this product to the supporting structure,
we advise you not to use mechanical or electrical
screwdrivers and to exercise moderate pressure
by hand on the fastening hooks.
WARNINGS:
be aware that the glue that join the laminated
plastic to the furniture, has to resist to
temperature not below 150 °C, to avoid the
unstuck of the panelling.
The rear wall, adjacent and surrounding surfaces
must therefore be able to withstand an
temperature of 90 °C.
FIG. 7
MAINTENANCE SCHEDULE
Clean the cooktop surface after every use as specified within this manual.
