USA
page 26
INSTALLER SECTION
3. DETERGENT DISPENSER INSTALLATION
3.1 Electrical connection
Follow the wiring diagram attached to the machine.
3.2 Water connection
a) Remove the cap from the hole and fit the delivery connection.
b) Correctly mount the injector
C
using the appropriate fixtures.
c) Connect the suction tube to the suction attachment of the dispenser (see pict. 4 - point
A
).
d) Connect the delivery tube to the other attachment of the dispenser, and the delivery fitting (see pict. 4
point
B
).
e) Insert the suction tube with filter in the detergent tank.
f) Prime the detergent and proceed to dispense.
3.3 Dispensing the detergent
The detergent dispenser capacity can be adjusted using a screwdriver as shown in picture 3.
Every
13
/
16
(2 cm) of product drawn into the tube corresponds to
1
/
64
cubic inches (0,25 cm³) equivalent to 0,01
oz (0.3 g - th a concentration of
1
/
16
oz/cubic inches - 1,2g/cm³). For proper dispensing see paragraph
6.2.
IMPORTANT:
DO NOT INVERT THE TUBES IN THE PRODUCTS; IF THIS
OCCURS IT WOULD RUIN THE METERING PUMPS AND COMPROMISE
DISHWASHER OPERATION.
4. TECHNICAL DATA AND USEFUL INFORMATION ON PUMPS
4.1 Drain pump (optional)
When installing, pay particular attention to the position of the emptying tube (see pict. 5).
Max. drain height
<39 inches (<1mt), there must be a trap downstream of the drain.
For the electrical connection see the wiring diagram notes.
max 39 inches (1 m
t)
pict. 5
fig. 3
A
B
C
min 1" 1/4
(3 cm)
Punto B
CONNECTION DIAGRAM
pict. 4
Содержание D-18
Страница 2: ......
