BlackWing MK 2013, Руководство пользователя

Страница: 26 / 40

8.0 INPUT SIGNAL SETTINGS
26 R599823 - Blackwing Essential mk2013 User Manual
Lamp Power
Set the lamp power used by the current Picture Profile:
Low: lamp is set to 180W
High: lamp is set to 230W.
To avoid any damage to the lamp, you can’t change the lamp power within 90 seconds from the projector startup or
60 seconds after lamp power change.
7.9 Reset Picture Profile
Prompt a confirmation to reset the current Picture Profile to default settings.
8.0 INPUT SIGNAL SETTINGS
8.1 HDMI Inputs
This menu is available if the selected active input is HDMI1 or HDMI2.
Input
• Auto: The input dynamic range is automatically detected and configured.
• Standard: Force dynamic range to 16-235.
• Enhance: Force dynamic range to 0-255.
• Super White: Force dynamic range to 16-255.
Check Input Levels
The following pattern is overlaid to current picture to confirm that the correct input level has been selected.
Use the Input Levels pattern to confirm the correct HDMI dynamic range setting.
Color Space
• Auto: The source color space is automatically detected and configured.
• YCbCr(4:4:4): Set color space to YCbCr 4:4:4.
• YCbCr(4:2:2): Set color space to YCbCr 4:2:2.
• RGB: Set color space to RGB 4:4:4.
Control with HDMI (CEC*)
• Off: By default the CEC(*) communications are disabled.
• On: Enables CEC(*) communications to be sent to the projector through HDMI cable.
(*) CEC stands for Consumer Electronic Control
8.2 Component
This menu is available if the selected active input is Component.
• Y Pb/Cb Pr/Cr: Select this option if the COMP. input is connected to a component video signal.
• RGB: Select this option if the COMP. input is used with a RGB video source.
8.3 Picture Position
Depending on your source, you may find that the picture should be adjusted into the screen, adjust the horizontal
and vertical position of the picture into the screen. Some signals may not be fully displayed, adjust this setting
properly when necessary.