BlackSys CH-200, Руководство пользователя

Страница: 23 / 44

23
USER MANUAL
※ You can set the motion detection function on the BlackSys Viewer : Configuration Settings >> Motion .
Or directly from the BlackSys App : BlackSys Settings >> Motion Detection .
※ White LED will blink while motion recording is active.
※ Motion detection may fail when the vehicle is in extreme lighting conditions.
※ Recording time during parking mode may vary depending on the vehicles’ battery voltage.
※ Motion recording may continue according to changes in the environment, the sensitivity must be set to in accordance with your parking environment.
(E.g. When parking in an alley or underground, frequent movements may interfere with motion recording if set on a high sensitivity.)
6. Time Lapse Recording
- When Time Lapse Recording is enabled in user settings, 30-second videos are recorded and saved in MotionMovie folder. Time Lapse Re-
cording captures at one frame per second when the vehicle is parked.
※ Each file is 30 seconds but the span is 7 minutes 30 seconds.
※ Event/Motion Detection Recording does not operate if Time Lapse Recording is enabled.
7. Driving Information Check
- Configuration setting → GPS function → Driving Information
After you have set the storage intervals for driving information on the configurations settings, the desired data points will then be saved
at every programed interval.
8. ADAS(Advanced driver assistance system) Guide
- LDWS : when vehicle speed keeps over 30km/h, function will be calibrated within 2~4 min. and Green LED is ON.
If camera detect lane departure when speed is over than settings, warning alarm comes and Green LED is Blink. (0.3sec.)
- FCWS : If camera detect collision with front vehicle when speed is over than settings, warning alarm comes and Green LED is Blink. (0.2sec.)
- FVSA : If front vehicle departure while vehicle speed is 0km/h, warning alarm comes and Green LED is Blink. (0.6sec.)