English
11
Pressing the Bluetooth switch while in Discoverable Mode will put your SONNET 120
Bluetooth amplifier into Scanning Mode.
Scanning Mode (fast LED flash)
Scanning Mode is used to reconnect any previously paired Bluetooth devices
to your SONNET 120 Bluetooth if they have travelled out of range or have been
disconnected. Ensure your previously paired Bluetooth device has Bluetooth
connectivity switched on. Press the Bluetooth switch once to put the SONNET
120 Bluetooth into Scanning Mode; your amplifier will ‘scan’ for previously paired
devices within range and attempt to reconnect, starting with the device that was
most recently connected. You will hear an audible tone from the amplifier to indicate
that a device has been successfully reconnected.
If you have previously paired any Bluetooth Devices to your SONNET 120 Bluetooth
amplifier it will power on in Scanning Mode. If your Bluetooth device is within
range and has Bluetooth connectivity switched on, your amplifier will automatically
reconnect to your device, allowing you to start streaming your music straight
away. Pressing the Bluetooth switch from Scanning Mode will set your amplifier to
Discoverable Mode in order to begin pairing a new device. At any time, you may
disconnect your Bluetooth device from your amplifier by either pressing and holding
the Bluetooth switch on the amplifier front panel for 3 seconds or switching off
the Bluetooth functionality of your device. You will hear an audible tone from the
amplifier to indicate that a device has been disconnected.
30. Bluetooth LED
The Bluetooth LED indicates which mode the Bluetooth is in (Discoverable/
Scanning). When the Bluetooth LED is unlit the Bluetooth connectivity is not active.
Rear Panel
Channel 1
31. Effect Loop Send
Connect to the (mono) input of an external effects unit here.
32. Effect Loop Return
Connect to the (mono) output of an external effects unit here.
33. D.I. Output XLR
This is a balanced output for connection to a PA, mixing desk or interface for
recording and monitoring. Using a good quality screened cable, the balanced XLR
connection provides a high quality signal, free of noise. The output signal is defined
by the selection of the Pre/Post switch (34).
NOTE:
Your Sonnet 120 acoustic amplifier will NOT be damaged by applying
Phantom power to the XLR Line Output, and will have no effect on the operation of
the amplifier.
34. Pre / Post Select
This switch affects which audio signal is sent to the XLR output (33);
PRE (switch OUT)
– the direct signal from the input source as received by Channel
1, taken after the PAD switch (3).
POST (switch IN)
– the full Channel 1 preamp signal of GAIN and EQ. This is taken
before the REVERB, H.P. FILTER, BRILLIANCE and MASTER controls.
Channel 2
35. Effect Loop Send
Connect to the (mono) input of an external effects unit here.
36. Effect Loop Return
Connect to the (mono) output of an external effects unit here.
37. D.I. Output XLR
This is a balanced output for connection to a PA, mixing desk or interface for
recording and monitoring. Using a good quality screened cable, the balanced XLR
connection provides a high quality signal, free of noise. The output signal is defined
by the selection of the Pre/Post switch (38).
NOTE:
Your Sonnet 120 acoustic amplifier will NOT be damaged by applying
Phantom power to the XLR Line Output, and will have no effect on the operation of
the amplifier.
38. Pre / Post Select
This switch affects which audio signal is sent to the XLR output (37);
PRE (switch OUT)
– the direct signal from the input source as received by Channel
1, taken after the PAD switch (14).
English
12
