14
13
POST (switch IN)
– the full Channel 2 preamp signal of GAIN and EQ. This is taken
before the REVERB, H.P. FILTER, BRILLIANCE and MASTER controls.
39. Footswitch (Optional Purchase)
The optional FS-17 footswitch, or any 2-way latching footswitch can be connected
here. The first switch labelled ‘Mute’ will mute the whole amplifier, and the second
switch labelled ‘Reverb’ will defeat the reverb on both channels.
40. MP3 / Line In
This is a stereo mini jack input. Connect the output of your audio device here and
adjust the player’s volume to match that of your instrument or voice to enable you
to play and/or sing along.
NOTE:
This connection is stereo. The Mix D.I. Output (41) will mix the incoming
stereo signal and output a mono version.
41. Mix D.I. XLR Output
This output is a low impedance, balanced XLR output for connecting directly to a
mixer or stage box. This will send a mix of both preamp channels (including reverb
and anything in the effects loops). This is taken just before the MASTER control.
42. Ground Lift
This switch can be used to remove the circuit-to-chassis ground connection of the
XLR output, which can help if experiencing hum or noise upon connecting to an
external device. If you do experience a hum when connecting the XLR Output (41)
to an external device, engage the Ground Lift by depressing the button to lift the
ground on the circuit.
43. USB Audio Socket
This Type B USB socket is for connection to a computer via a suitable lead (not
supplied). Standard audio drivers are used to connect the amplifier to a PC, Mac or
other applicable recording device. No specific drivers are required.
A Camera Connection Kit can also be used to connect an iPad or iPhone for
recording. This will enable the amplifier to be recorded via your chosen mobile DAW.
For a guide on low latency USB recording visit:
www.blackstaramps.com/usbrecording
NOTE:
Always connect the amplifier via a main USB port, often found on the rear of
the computer. The amplifier will appear as an audio capture device within recording
software.
Blackstar RecRoute
Using the RecRoute software (enter web address here), the routing of the USB
Audio recording output can be assigned to be either of the following:
Mono
– Mix of Channel 1 and Channel 2, with stereo reverb
Split
– Individual Channel 1 (Left) and Channel 2 (Right), with no reverb
An adjustable Boost can also be applied to either configuration via the software, if
required. The Boost level setting remains stored on the amplifier when disconnected
from the software, and will be engaged when recording via your PC, Mac or mobile
device.
44. Power Switch
This switch is used to turn the amplifier on and off.
45. Mains Input
The supplied detachable mains power cable is connected here. Always ensure the
Power Switch (44) is in the OFF position before applying mains power. The cable
should only be connected to a power outlet that is compatible with the voltage,
power and frequency requirements stated on the rear panel. Never break off the
earth (ground) pin on the mains cable. If in doubt seek advice from a qualified
technician.
English
English
