Version : 2020.1
24
Instruction manual
We congratulate you on the purchase of your electric fence unit. You have acquired a high-quality appliance,
which corresponds to the current safety regulations as well as to the relevant EC-guidelines (CE). With this
appliance, you can improve the security of your fence system. Environmental conditions and incorrect
installation can influence your fence system; therefore absolute security cannot be guaranteed. For this
reason the seller gives no assurance that the fence system is safe against outbreak. To achieve the best results
and correct installation please read the following and the enclosed specific instruction manual.
Installation of an electric fence system : (Figure 1)
1 Electric fence appliance
10 Gate component
2
Earthing
cable
11
Warning-plate
3 Permanent fencing post
12 Corner insulator
4 Rust-protected grounding rod
13 Distance insulator
5 Underground cable high volt. resist.
14 Tape, wire
6
On
/
Off
switch
15
Mobile
post
7 Fence connecting cable
16 Wire tensioner
8
Connecting
cable
17
Fence
connector
9 Gate handle system
18 Lightning protection
Safety instructions :
Please follow this instruction exactly and store it well when not in use.
Electric fences shall be installed and operated so that they cause no electrical hazard to persons, animals or their
surroundings.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance. (A2:06)
Contact with electrified fences must be avoided, especially with the head, neck or upper body. Do not climb on, over or through the
fence. A gate or other type of passage must be used to pass through the fence.
Electric fence constructions, which are likely to lead to the entanglement of animals or persons, shall be avoided.
An electric fence shall not be supplied from two (or more) different energizers or from independent fence circuits of the same
energizer.
For any two (or more) different electric fences, each supplied from a different energizer independently timed, the distance between the
wires of the two electric fences shall be at least 2.5 m. If this gap is to be closed, this shall be effected by means of electrically non-
conductive material or an isolated metal barrier.
An energizer shall not electrify barbed wire or razor wire.
Any part of an electric fence which is installed along a public road or public thoroughfare shall be identified at frequent intervals by
warning plates securely fastened to the fence posts or firmly clamped to the fence wires. The background colour of both sides of the
warning plate shall be yellow. The inscription on both sides of the warning plate shall be black and shall be the substance of TAKE
CARE – ELECTRIC FENCE or the symbol
. The size of the warning plates shall be at least 200 mm 100 mm.
A distance of at least 10 m shall be maintained between the energizer earth electrode and any other earthing system such as the
power supply system protective earth or the telecommunication system earth.
Except for low output battery-operated energizers, the energizer earth electrode shall penetrate the ground to a depth of at least 1 m.
Care shall be taken to avoid any damage to cables or pipelines.
Connecting leads that run inside buildings shall be effectively insulated from the earthed structural parts of the building. This may be
achieved by using insulated high voltage cable.
