5
shows ground when the door is open.
• VIOLET WIRE - Positive door trigger (+).
Connect to the door switch circuit wire that
shows +12V when the door is open. This
type of circuit is common on Ford vehicles.
• YELLOW WIRE - +12V Ignition input.
Connect to a main ignition wire at the
ignition switch harness. This wire shows
+12V when the ignition is on and while
cranking. The voltage must not drop when
the car is starting.
NOTE:
Do not connect the alarm module
until the installation is complete. Turn on the
ignition first, then plug in the 9-pin harness
followed by the 3-pin large harness so the
alarm will power up in the disarm state. If
the alarm is plugged in without the ignition
on, it will automatically power up in the
alarming state.
Plug in Connectors
2-Pin Red Connector:
Plug-in port for
LED. Mount LED where it may be easily
seen from either side of the vehicle.
2-Pin Blue Connector:
Plug-in port for
valet switch. Mount switch in an area
accessible from the driver’s seat.
3-Pin Large White Door Lock Connector:
Plug-in connector for door lock harness or
optional door lock relay module.
• BLUE WIRE - unlock output (-) 500mA.
• RED WIRE - not used.
• GREEN WIRE - lock output (-) 500mA.
3-Pin Small White Connector:
Plug-in
port for dual stage shock sensor.
Automatic Output Circuit Breaker
When any (-) output is connected to (+)
constant in error, the system detects the
short circuit automatically and shuts down
that output until the error is corrected
and ignition reset (on-off) is performed.
While the short circuit is detected, the
siren will chirp 4 times and the park lights
will flash 4 times during arm and disarm.
LED will continue to flash 2-9 times
depending on the output shorted until
ignition reset is performed (In both arm
and disarm mode).
Programmable Features
Function
Buttons
1 Chirp
2 Chirps
Shock Sensor
3-3-1
Off
On
Arming Chirps
2-1-1
Silent
Normal
Ignition Locking
1-3-2
Off
On
Door Lock Pulse Length
1-3-1
3 Seconds
.75 Second
Door Unlock Pulse
2-2-1
Double
Single
Passive Locking
3-3-2
Off
On
Arming Mode
1-2-3
Active
Passive
Anti-Carjack Activation
2-1-3
Disabled
Enabled
*default settings in
bold
SHORT CIRCUIT LED INDICATIONS
2 Flashes = Lock Output
3 Flashes = Unlock Output
4 Flashes = Auxiliary Output
6 Flashes = Starter Defeat Output
7 Flashes = Dome Light Output
8 Flashes = Auxiliary 2 Output
9 Flashes = Passenger Unlock Output
BW2450.qxd 6/11/2009 4:12 PM Page 5
