6
Entering Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5
times.
• The siren will chirp, to indicate
entering program mode.
3. Press the transmitter buttons shown
to change the desired feature.
• The siren will chirp once or twice to
indicate the setting.
4. Repeat the programming sequence to
change other selections.
5. Turn off ignition to save changes.
Complete Default Reset
Following this procedure will set all
programmable features to default settings.
1. Enter System Programming.
2. Press Transmitter Button 3 three
times.
• The siren will chirp 3 times
indicating all programmable features
are reset to factory default settings.
5. Turn off ignition.
Programmable Features
Shock Sensor. Selects whether or not the
shock sensor will trigger the alarm.
Arming Chirps. Select Normal or Silent.
Ignition Locking. Automatically locks and
unlocks the doors with the ignition. The
system will not lock the doors if any door
is open when the ignition is turned on.
Door Lock Pulse Length. Sets the lock
pulse length for normal (.75 second) or
vacuum locking systems (3 seconds).
Door Unlock Pulse. Selects between a
single and double unlock pulse.
Passive Locking. Allows the doors to
automatically lock with Passive Arming.
Arming Mode. Select either manual arming
(Active) or automatic arming (Passive).
Anti-Carjacking Activation. Enables or
disables the anti-carjacking feature.
Test System
Arm and disarm system, checking that the
siren chirps and parking lights are
functioning normally, as well as Passive
Arming and Emergency Override. Make
sure that the programmed features are
performing correctly.
Test the doors and hood/trunk inputs
making sure all doors trigger the system.
Test the starter defeat feature (if installed).
Adjust the shock sensor.
Tie up wires, and replace any dash panels.
Make sure the customer knows the
location of the valet/override switch.
Adding Transmitters
To add a new transmitter to the system
have the desired transmitters ready and
follow the Code Learning sequence.
To enter Code Learning Mode:
1. Turn the ignition on, off, on, off and
leave on.
• The siren will chirp once.
2. Press the Valet switch for 5 seconds.
• The siren will chirp 3 times.
3. Press the transmitter’s Lock Button.
• The siren will chirp once.
4. Repeat step 3 for each additional
transmitter (max 3).
5. Turn off the ignition.
• The siren will chirp once.
NOTE: If a transmitter is lost or stolen, make
sure to code all 3 transmitter memory
BW2450.qxd 6/11/2009 4:12 PM Page 6
