ENG
LIS
H
ENG
LIS
H
|
Owner’s Manual
ENG
LIS
H
❷
❶
❸
STEP 01
Ensure that the gas regu-
lator is angled towards the rear of
the appliance, and that the LP bottle
is positioned below the regulator.
!
WA r n I n G
Do not lean over the appli-
ance while lighting.
!
WA r n I n G
If ignition does NOT
occur in 5 seconds, turn
burner controls OFF, wait
5 minutes and repeat
lighting procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner
and could accidentally/
inadvertently ignite with
risk of injury.
IGnITIon |
PIEZo-ELECTrIC
PROPANE BURNER OPERATION
For proper ignition and operation of the appliance follow the steps below.
STEP 02
❶
Push the control knob in to start
gas flowing.
❷
Turn the control knob counter-
clockwise to activate the starter.
❸
Adjust the temperature to
desired level.
one half turn
STEP 01
Ensure that the LP tank
is properly connected to the unit.
Turn gas ON at the LP cylinder
by slowly turning the OPD hand-
wheel halfway.
Ignition | Piezo-Electric
ENG
LIS
H
3-7mm
TroUBLESHooTInG
Visit
BLACKSTonEProDUCTS.CoM/SUPPorT
for additional
troubleshooting.
Section 01
PIEZO-ELECTRIC IGNITION
SYMPTOMS
01. Burner will not ignite with piezo ignition system
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your appli-
ance with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
If you
CAN
ignite your appliance with a match
POSSIBLE CAUSES
SOLUTION
01. Ignitor wire misaligned.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
02. Damage to the ignition system.
Contact customer service for replace-
ment parts.
If you
CAN NOT
ignite your appliance with a match
POSSIBLE CAUSES
SOLUTION
03. Burner tubes are not
receiving propane.
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
Troubleshooting
Model 1967
19
Содержание 1967
Страница 36: ...ENGLISH ENGLISH North Atlantic Imports LLC 1073 West 1700 North Logan UT 84321 Blackstoneproducts com ...
Страница 72: ...FRANÇAIS FRANÇAIS North Atlantic Imports LLC 1073 West 1700 North Logan UT 84321 Blackstoneproducts com ...
Страница 108: ...ESPAÑOL ESPAÑOL North Atlantic Imports LLC 1073 West 1700 North Logan UT 84321 Blackstoneproducts com ...