Black Mountain Hutto, Руководство пользователя

Страница: 31 / 49

© Black Mountain Bikes
02
LOOSEN THE YOKE BOLT
Remove the rubber bungs from the front and
rear of the top tube. Keep these, as you’ll be
re-fitting them again later in step 06. Using the
two 5mm hex keys at the same time on both
sides, loosen the bolts on the rear yoke, but do
not remove all the way. You'll fully remove them
in step 04.
TIP: You may find it easier to lay the bike flat to
help control the frame's movement as you make
these changes.
REMOVE THE FRONT TOP-TUBE BOLT
It’s a good idea at this stage to protect the paintwork
on the front end of the rear arm with something like
a clean cloth. Using both the 5mm hex keys, loosen
and then remove the top-tube bolt. Allow the front
end of the rear arm to drop a little.
REMOVE 'TOP HAT' BUSHINGS
Important: Once the front bolt is out, carefully
remove the two black plastic ‘Top Hat’ bushings
form the frame. The bushings are important and
are there to protect the frame. You will need
them again in step 05 and to ensure bolts re-
tighten correctly.
01
03
CHANGING MODES: ONE TO TWO
03
CAUTION: The frame may want to 'collapse'
as you remove these bolts. Support the
frame to control its movement and be careful to
avoid trapping or pinching your fingers/hands.
32
Kapel_Hutto_Manual OCT2019ALv3.indd 32 28/11/2019 14:13