6
SEA FURY Item code: BH148
.
Instruction Manual
Secure
3x15mm
Secure
PARTS REQUIRED
Only including oleo struts.
5x35mm
3x15mm
Secure
5x35mm
Collar
Electric not included.
73.5mm
28mm
21mm
44mm
Repeat the procedure to install the second aileron
linkages in the opposite wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
II. INSTALLING THE FLAP
Flap install as same as the way of aileron. Repeat
step #1 - #4 on the part I
(page 4,5)
to install the flap.
III. INSTALLING ELECTRIC GEAR
RETRACTS
Bend and cut.
Silicone Tube
Flaslink
Pushrod wire Control horn
Attach the clevis to the outer hole in the servo arm.
Install a silicone tube on the clevis.
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.