11
SEA FURY Item code: BH148
.
Instruction Manual
Elevator control horn
Drill a hole
1.5 mm
When you are sure that everything is aligned correctly,
mix up a generous amount of 30 minute epoxy. Ap-
ply a thin layer to the top and bottom of the stabilizer
mounting area and to the stabilizer mounting platform
sides in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your measurements one
more time before the epoxy cures. Remove any ex-
cess epoxy using a paper towel and rubbing alcohol
and hold the stabilizer in place with T-pins or masking
tape.
Top side and
bottom side.
A/B Epoxy glue
After the epoxy has fully cured, remove the mask-
ing tape or T-pins used to hold the stabilizer in place
and carefully inspect the glue joints. Use more epoxy
to fill in any gaps that may exits that were not filled
previously and clean up the excess using a paper
towel and rubbing alcohol.
Top side
C/A glue.
ELEVATOR PUSHROD INSTALLATION
X. INSTALLING VERTICAL STABILIZER
Rudder install as same as the way of aileron.
1)
Using a modeling knife, remove the covering on
the top of the fuselage for the vertical stabilizer.
Remove the covering.
Elevator pushrod
Bottom side.
Silicone Tube
1)
Using pliers, carefully make a 90 degree bend
down at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
2)
Insert the 90 degree bend down through the
hole in the servo arm. Install one nylon snap keeper
over the wire to secure it to the arm. Install the servo
arm retaining screw.
Snap keeper
Elevator servo
Secure.
Cut.
Flaslink
Pushrod wire
servo arm