MESSERSCHMITT BF-109E Item code: BH146
.
Instruction Manual
6
PARTS REQUIRED
4. INSTALLING THE AILERON LINKAGES
Installing the aileron linkages as pictures below.
100mm
Snap keeper.
M2
lock nut
Repeat the procedure to install the second aileron
linkages in the opposite wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
II. INSTALLING THE FLAP
Flap install as same as the way of aileron.
Repeat step #1 - #4 on the part I (page 4,5)
to install the flap.
3)
Repeat the procedure to install the
control horn on the opposite aileron.
Flaslink
Pushrod wire Control horn
Bend and cut.
Silicone Tube
Push in
III. INSTALLING AIR RETRACTABLE
LANDING GEAR
Place the retract to the wing and pull out the air tube
through the wing section.
Secure the air retract to the wing.
Install the tube to the air retract.
3x6mm 3x4mm
3x15mm
5x35mm
