Black Horse Model Focke-Wulf FW190A, Инструкция по эксплуатации

Страница: 21 / 34

21
Focke-Wulf FW190A-
Item code:BH87
INSTRUCTION MANUAL.
epoxy cures. Remove any excess epoxy us-
ing a paper towel and rubbing alcohol and hold
the stabilizer in place with T-pins or masking
tape.
C/A glue
5. When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting area
and to the stabilizer mounting platform sides
in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your measure-
ments one more time before the
Epoxy glue
Mark line
Bottom side.
R e m o v e
covering
4. Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
When cutting through the covering to
remove it, cut with only enough pressure
to only cut through the covering it’s self.
Cutting into the balsa structure may
weaken it. This could lead to possible fail-
ure during flight.
Remove
covering
2 Using a modeling knife, cut away the
covering from the fuselage for the stabilizer
and remove it.
3. Mark the shape of the vertical on the left
and right sides onto the horizontal stabilizer
using a left-tip pen.