Instruction Manual.
5
2)
Test fit the dihedral brace into each wing
half. The brace should slide in easily. If not,
use 220 grit sandpaper with a sanding block
and sand down the edges and ends of the
brace until it fits properly.
WING ASSEMBLY.
1) Location the aluminium wing dihedral
brace.
Epoxy glue.
Bottom side.
Aluminium.
3)
Apply masking tape at the wing join to
hold the wing halves together securely.
INSTALLING THE AILERON LINKAGE.
1) Thread one nylon adjustable control
horn onto each aileron torque rod. Thread the
horns on until they are flush with the ends of
the torque rods.
2) Thread one nylon clevis at least 5/16”
onto each of the two 2mm x 100mm threaded
wires.
3) With the aileron servo centered, install
the servo arm onto the servo. The arm should
be installed so it is parallel with the trailing edge
of the wing.
Masking tape.
