Instruction Manual.
15
Throttle
servo.
Elevator
servo.
Rudder
servo.
INSTALLING THE SWITCH.
1) Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2) Secure the switch in place using the
two machine screws provided with the radio
system.
Switch.
3) Do not permanently secure the receiver
and battery until after balancing the model.
1) Plug the servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch.
2) Wrap the receiver and battery pack in
the protective foam to protect them from
vibration.
4) Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
INSTALLING THE RECEIVER AND BATTERY.
Plywood tray.
Battery.
Tie wrap.
Battery.
