PROCTOR Item code: BH154
.
Instruction Manual
8
V. SERVOS INSTALLATION
INSTALLING THE FUSELAGE SERVOS
1)
Install the rubber grommets and brass collets
into the elevator, rudder and throttle servos. Test fit
the servos into the servo tray. Trim the tray if neces-
sary to fit your servos.
2)
Mount the servo to the tray using the mounting
screws provided with your radio system.
Nose gear servo
Elevator servo
Rudder servo
Drill a hole 2.5mm
and
secure
3 x 12mm
1)
Elevator install as same as the way of aileron
.
Please see pictures below.
VI. INSTALLING HORIZONTAL
STABILIZER
2)
Using a modeling knife, carefully remove the film
covering from the tail slots at the rear of the fuselage.
Make sure that you do not remove any wood from the
slots as this will affect the alignment of the tail.
3)
Draw a center line onto the horizontal stabilizer.
Then put the horizontal into the fuselage.
Trim the covering
from the tail slots.
C/A glue.
