PROCTOR Item code: BH154
.
Instruction Manual
4
1. INSTALLING THE AILERONS
I. AILERON
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Temporary pin to
keep hinge centered.
Test fit the ailerons to the wing with the hinges. If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
See pictures below:
2. INSTALLING THE AILERON SERVOS
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
Servo tray
Remove the covering
Aileron
Flap
Bottom side.
2x10mm
5x30mm
3x12mm
3x15mm
REPLACEMENT SMALL PARTS
3x4mm
