PROCTOR Item code: BH154
.
Instruction Manual
12
Secure the EDF.
wire cable.
wire cable.
Trim
wire cable.
Servo nose gear
X. INSTALLING THE RECEIVER,
ESC
AND BATTERY
1)
Plug the servo leads and the switch lead
into the receiver. You may want to plug an aileron
extension into the receiver to make plugging in the
aileron servo lead easier when you are installing
the wing. Plug the battery pack lead into the switch.
2)
Wrap the receiver and battery pack in the
protective foam to protect them from vibration.
Use a rubber band or masking tape to hold the
foam in place.
3)
Position the battery pack and receiver is as
picture below.
Do not permanently secure the receiver and battery
until after balancing the model.
4)
Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for the
antenna to exit.
Battery of EDF
ESC
UBEC
Battery of
receiver
