SEA FURY
Item code: BH113-A
Instruction Manual
5
3)
Using the thread as a guide and using
masking tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you have
pulled the servo lead out, remove the masking tape and
the servo lead from the thread.
4)
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
3. INSTALLING THE AILERON CONTROL HORN
1)
Remove the covering from the slot on the
bottom of the aileron.
2)
Insert the control horn into the slot and
secure it by A+B Epoxy glue.
4. INSTALLING THE AILERON LINKAGES
3)
Repeat the procedure to install the control
horn on the opposite aileron.
Installing the aileron linkages as pictures below.
100mm
Snap keeper.
M2
lock nut
1. A+B Epoxy glue
2. Push in
Aileron
control horn
Remove
the covering
Secure
Drill a hole
1.5 mm
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
Bend and cut.
Flaslink
Pushrod wire Control horn
Repeat the procedure to install the second aileron
linkages in the opposite wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
II. INSTALLING THE FLAP
Flap install as same as the way of aileron.
Repeat step #1 - #4 on the part I (page 4,5)
to install the flap.
