SEA FURY
Item code: BH113-A
Instruction Manual
4
2. INSTALLING THE AILERON SERVOS
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Temporary pin to
keep hinge centered.
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the covering from
over the pre-cut servo arm exit hole on the aileron servo
tray / hatch. This hole will allow the servo arm to pass
through when installing the aileron pushrods.
1. INSTALLING THE AILERONS
I. AILERON
Test fit the ailerons to the wing with the hinges.If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
REPLACEMENT SMALL PARTS
Bottom side.
Flap
Aileron
2
5
2
1
3x4mm
3x15mm
5x35mm
3x10mm
2x10mm
3x12mm
7
3x15mm
8
6
4x30mm
4x30mm
4x70mm
3
3
1. Door mounting wheel.
2. Retract main gear (right & left).
3. Wheels.
4. Plastic - engine mount.
5. Wood - motor mount
6. Spinner.
7. Fuel Tank
8. Tail gear set.
4
