SEA FURY
Item code: BH113-A
Instruction Manual
10
3x12mm
Secure
1)
Elevator install as same as the way of aileron
.
Please see pictures below.
VII. INSTALLING HORIZONTAL
STABILIZER
2)
Using a modeling knife, cut away the covering
from the fuselage for the stabilizer and remove it.
3)
Draw a center line onto the horizontal stabilizer.
Then put the horizontal into the fuselage.
Push in
4)
Check the fit of the horizontal stabilizer in its
slot. Make sure the horizontal stabilizer is square and
centered to the fuselage by taking measurements, but
don’t glue anything yet.
B
B
A
A
5)
With the horizontal stabilizer correctly aligned,
mark the shape of the fuselage on the top and bottom
of the tail plane using a water soluble / non permanent
felt-tip pen.
Check to mark sure the wing and stabilizer are
paralell. If they are not, lightly sand the opening
in the fuselage for the stabilizer until the stabilizer
is paralell to the wing, but don’t glue anything yet.
A
A
A = A
center line
Mark line
Top side
Top side and
bottom side.
Remove
the covering.
6)
Remove the stabilizer. Using the lines you just
drew as a guide, carefully remove the covering from
between them on the top and bottom of the tail plane
using a modeling knife.
When cutting through the covering to remove it, cut
with only enough pressure to only cut through the
covering it’s self. Cutting into the balsa structure may
weaken it. This could lead to possible failure during
flight.
