SEA FURY
Item code: BH113-A
Instruction Manual
13
1)
Set the tail wheel assembly in place on the ply-
wood plate. The pivot point of the tail wheel wire should
be even with the rudder hinge line and the tail wheel
bracket should be centered on the plywood plate.
IX. MOUNTING THE TAIL WHEEL
BRACKET
3 x 12mm
2)
Mark the locations of the two mounting screws.
Remove the tail wheel bracket and drill 2mm pilot holes
at the locations marked.
3)
Secure the tail wheel bracket in place using
three 3mm x 12mm wood screws. Be careful not to
overtighten the screws.
Drill a hole
2mm diameter
Mark point
Silicone Tube
Secure
1)
Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting holes
through the fuselage side.
2)
Secure the switch in place using the two machine
screws provided with the radio system.
X. INSTALLING THE SWITCH
Switch of Receiver
Switch of engine
1)
Plug the servo leads and the switch lead into
the receiver. You may want to plug an aileron extension
into the receiver to make plugging in the aileron servo
lead easier when you are installing the wing. Plug the
battery pack lead into the switch.
XI. INSTALLING THE RECEIVER
AND BATTERY
