Black+Decker KS501, Руководство пользователя

Страница: 8 / 76

8
ENGLISH
(Original instructions)
4. Shoe plate
5. Dust extraction outlet (KS701E and
KS701PE only)
6. Pendulum Stroke dial (KS701PE only)
Assembly
Warning! Before attempting any of the
following operations, make sure that the
tool is switched off and unplugged and that
the saw blade has stopped. Used saw
blades may be hot.
Fitting the saw blade (fig. A - KS701E and
KS701PE)
• Hold the saw blade (7) as shown, with
the teeth facing forward.
• Push the locking lever (3) away from the
shoe plate (4).
• Insert the shank of the saw blade into the
blade holder (8) as far as it will go.
• Adjust the saw blade support roller (17)
as described above.
• Release the locking lever (3).
Fitting the saw blade (fig. A - KS501)
• Before ftting or removing the saw blade
(7) the saw blade support roller (17)
must be adjusted to the rear position so
that it does not contact the blade.
• Loosen (do not remove) the two screws.
(18).
• Hold the saw blade (7) with the teeth
facing forward.
• Insert the shank of the saw blade (7) into
the blade holder (8) as far as it will go.
• Slightly tighten the two screws (18)
alternately to position the blade, then
fully tighten the two screws (18).
• Adjust the saw blade support roller (17)
as described above.
• To remove the saw blade (7), turn both
screws (18) one turn counterclockwise.
Connecting a vacuum cleaner to the tool
(fig. B - KS701E and KS701PE only)
• Slide the vacuum nozzle (9) into the dust
extraction outlet (5).
Residual risks
Additional residual risks may arise when
using the tool which may not be included in
the enclosed safety warnings. These risks
can arise from misuse, prolonged use etc.
Even with the application of the relevant
safety regulations and the implementation of
safety devices, certain residual risks cannot
be avoided. These include:
• Injuries caused by touching any
rotating/moving parts.
• Injuries caused when changing any parts,
blades or accessories.
• Injuries caused by prolonged use of a
tool. When using any tool for prolonged
periods make sure you take regular
breaks.
• Impairment of hearing.
• Health hazards caused by breathing dust
developed when using your tool
(example:- working with wood, especially
oak, beech and MDF).
Use
Adjusting the shoe plate for bevel cuts
(fig. C)
Warning!
Never use the tool when the shoe
plate is loose or removed.
The shoe plate (4) can be set to make either
a straight cut or a bevel cut at an angle of
45°.
• Loosen the screw (9) (approximately 3
full turns).
• Pull the shoe (4) forward, rotate the shoe
to the left or right and push it back into
the 45° location. (KS701E and KS701PE
only).
• Push the shoe (4) back, rotate to the
right and pull it back into the 45°
location. (KS501 only).
• Tighten the screws.