English
6
Fig. O
15
16
Cleaning the filters (Fig. K, L, O, P - R)
• Pull back on the dust canister release button
16
to
release and remove the dust canister
8
from the
vacuum
15
as shown in Fig. K.
• Use your index finger and thumb to pinch the filter
housing tabs
17
and lift the filter housing
18
from the
dust canister as shown in Fig. L.
• Once the filter housing is removed from the dust
canister, use your index finger and thumb to pinch the
filter housing tabs
17
and rotate the filter
22
counter-
clockwise and remove it from filter housing as shown
in Fig. P.
• Remove the foam filter
23
from the filter housing as
shown in Fig. Q.
• Shake or lightly brush any loose dust off of the foam
filter
23
and filter
22
.
• Rinse out the dust canister
8
with warm soapy water.
• Wash the filters with warm soapy water.
• Ensure the filters are completely dry before refitting the
filters into the filter housing
18
.
• Refit the clean and dry foam filter
23
into the filter
housing
18
.
• Refit the clean and dry filter
22
into the filter housing
18
by aligning the filter locks
24
, located on the sides
of the filter, with the filter housing slots
25
, located on
the sides of the filter housing, and turn the filter clockwise
until it locks firmly into position as shown in Fig. R.
• Install the filter housing into the dust canister
8
ensuring the dust canister slots
19
align with the filter
housing tabs
20
as shown in Fig. M.
• Install the dust canister onto the vacuum, until it “clicks”
firmly into position.
nOTE:
Ensure the dust port
21
is placed towards the
main handle
2
of the vacuum and the dust canister
release button
15
is facing away from the vacuum
16
as shown in Fig O.
iMPORTAnT:
Maximum dust collection will only be
obtained with clean filters and an empty dust canister.
If dust begins to fall back out of the product after it is
switched off, this indicates that the dust canister is full and
requires emptying.
• Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
• It is very important that the filters are completely dry
and correctly in position before use.
Fig. P
17
22
18
Fig. Q
18
23
Fig. R
24
17
25
22
25
18
Removing and cleaning the rotary brushes
(Fig. S, T, U, V, W)
CAUTION:
To reduce the risk of injury from
moving parts, disconnect the floor brush from the
vacuum before cleaning or servicing.
• To remove the rotary brush
26
from the floor brush
9
use a coin or straight screwdriver to rotate the lock
27
on the lock plate
28
to the unlocked position
29
as
shown in Fig. S.
• Remove the lock plate
28
.
• Lift the rotary brush up and slide the drive belt
31
off
to the side as shown in Fig. T. The rotary brush
26
can
now be removed.
nOTE:
The end pieces
32
are also removable allowing
you to clear the brushes of any hair or other debris that
may have accumulated as shown in Fig. U.
