Page 11
SET UP & USE
C: Align the holes in the top rail with those
in the top of the unit as shown in Fig. B
D: Secure the top rail to the unit with the
3/8 Screws as shown in Fig. C.
WARNING:
For safety reasons, all four (4)
screws MUST be securely fastened.
NOTE:
Before installing unit,
the top rail
must be assembled on
the unit.
INSTALL THE ACCORDION
PANELS
NOTE:
Top rail and Sliding Panels at each
side are offset to provide the proper
pitch to the rear of (5/16).
This is necessary for proper condensed
water utilization and drainage. If you are
not using the Side Panels for any reason,
this pitch to the rear must be maintained.
Hold the Accordion Panel in one hand
and gently pull back the center to free
the open end. See Fig.1
B. Slide the free end “I“ section of the panel
directly into the cabinet as shown in Fig.
2. Slide the panel down. Be sure to leave
enough space to slip the top and bottom
of the frame into the rails on the cabinet.
C. Once the panel has been installed on
the side of the cabinet, make sure it sits
securely inside the frame channel by
making slight adjustments. Slide the top
and bottom ends of the frame into the
top and bottom rails of the cabinet. Fig.
3.
D. Slide the panel all the way in and repeat
on the other side.
NOTE:
If storm window blocks AC, see Fig.
11.
w sash
oam
re
r
odels
are
00
dels
eather stripping
Fig. B
w sash
oam
)
are
r
odels
ware
000
dels
eather stripping
Fig. C
indow sash
seal foam
(1)
rdware
2)
e(for
h models
ardware
10000
h models
1/12 )
eather stripping
)
Fig. 1
" "section
Top Rail
Bottom Rail
Top Rail
Bottom Rail
Top left
Top right
W
INSIDE
Vinyl-Clad Windows
INSIDE
Fig. 2
" "section
Top Rail
Bottom Rail
Top Rail
Bottom Rail
Top left
Top right
Wooden Windows
INSIDE
Vinyl-Clad Windows
INSIDE
Fig. 3
Fig. 4
" "sectio
Top Rail
Bottom Rail
Top Rail
Bottom Rail
Top left
" "sectio
Top Rail
Bottom Rail
Top Rail
Bottom Rail
Top left
" "section
Top Rail
Bottom Rail
Top Rail
Bottom Rail
Top left
Top Rail
Bottom Rail
Top left
Top right
