PW2750 Hot Water Pressure Washer Manual
8
After starting the engine, you can turn on the LP fuel. Turn the water heater on. When the water is heated, trigger the gun and hot water
will come out. Trigger back and the water will stop. Use different spray nozzles to adjust the water flow rate. Adjust/reduce the engine
speed to increase/lower the water pressure.
As you trigger the gun, the heater will continue to heat the water to maintain constant temperature. Check the flame from the observation window. If
no flame, or if water is too cold, adjust the temperature by turning the Min/Max knob.
Detergent only works in low pressure and cannot be injected under high pressure. After you install the black spray nozzle, install the injector to the
pump. Then put the injector strainer into the detergent container. Detergent vs. Water ratio: 1: 10
After use, put the injector into clean water to clean off detergent.
The Safety Protector on the wand will help ensure that a firm grip on the handle
will allow high pressure water through the hose.
Do not shut off the water source when in operation, or it will cause damage to the pump.
STOP!
If you have questions about maintenance procedures described in this manual, call 1-888-287-6981 , Monday - Friday, 8 AM - 4 PM Central Time.
Never perform maintenance procedures while this tool is running. Allow this tool to cool before commencing any maintenance
procedures. Keep heat, sparks and flame away.
Improper maintenance and/or failure to correct any problems prior to operating this tool can cause a malfunction which could cause death
or serious injury. Always follow the inspection and maintenance recommendations and schedules in this manual.
Do not attempt to work on or service the pump, work is only to be completed by authorized service agents. Any work completed outside
the service agency will void warranty. Only qualified repair personnel must perform service.
