PW2750 Hot Water Pressure Washer Manual
5
PREPARING THE HOT WATER PRESSURE WASHER FOR USE
STOP!
The following section describes the required steps for preparing this TOOL for the first use. Failure to correctly perform these steps can
damage this tool and/or shorten its life. If still unsure about how to perform any of these steps after reading this section, call
1-888-287-6981 Monday - Friday, 8 AM - 4 PM Central Time for customer service.
If this is being used for the first time, the following few steps are required to prepare it for operation:
Add Oil to Engine
This Engine requires High Detergent Motor Oil, SAE 5W-30 engine oil to function. Engine oil is a major factor affecting engine performance
and service life. When new from the package, this tool contains no oil in either the engine crankcase or pump. Add the correct quantity of oil before
operating this tool for the first time. When replenishing oil for subsequent use, always determine that this tool has the correct quantity of oil.
Oil Capacity
30 ounces (0.9 Liters)
Oil Type Recommended
High Detergent Motor Oil, SAE 5W-30
To add oil:
1. Confirm that this hot water pressure washer is on a level surface.
2. Unscrew the oil filler/dipstick cap from the engine.
3. Using a funnel, add high detergent motor oil to fill the engine crankcase to the correct quantity as stated above. SAE10W-30 oil is recommended
for general, all-temperature use. When the engine crankcase is full, the oil level should reach the lower lip of the oil fill opening.
4. Replace the oil filler/dipstick cap.
Add Oil to Pump
Do not attempt to work on or service the pump, work is only to be completed by authorized service agents. Any work completed outside
the service agency will void warranty. Only qualified repair personnel must perform service.
This Pump requires Air Compressor Oil, SAE Grade 30 oil to function. Oil is a major factor affecting performance and service life. When
new from the package, this tool contains no oil in either the engine crankcase or pump. Add the correct quantity of oil before operating this tool for
the first time. When replenishing oil for subsequent use of this tool, always determine that this tool has the correct quantity of oil.
Oil Capacity
10 ounces (0.3 Liters)
Oil Type Recommended
Air Compressor Oil, SAE Grade 30
To add oil: Remove the oil cap above the Pump. Use the observation hole to review the oil level. Do not over fill.