Black Box ServSensor JR EME102A, Руководство пользователя, Страница: 13 / 135

11
CONTENTS
11
IPSet.exe first checks the IP address to see if it already assigned. Next
it will assign the IP address and then it will check that the address was
successfully assigned. If all is well then
IPSet.exe will report that the
assignment is Complete.
You can verify the IP assignment by using ping or by using a browser
to access the ServSensor JR. To use a browser enter the address:
http://<ip_address>
depending on the IP address that you have assigned.
Using a Web browser to assign the IP address.
The ServSensor JR is shipped with the IP address 192.168.0.100
You can enter this IP address into your web browser and use the
browser to change the IP address to the new address. For example enter
http://192.168.0.100
into the URL of the web browser and hit return. Once the page has
loaded you can press the Network tab and enter a new IP address for
the ServSensor JR.
However, before you can load the web page you usually have to set up
the routing table in the host computer. This is because the IP address
192.168.0.100 is probably on a different subnet than the PC. In the
usual case the PC will try to connect to 192.168.0.100 using the default
gateway, which is not what you want.
To set up the routing table, open a DOS window and at the command
prompt enter
route add 192.168.0.100 10.1.1.20
where 10.1.1.20 is the IP address of the Ethernet interface that the
ServSensor JR is plugged into using the crossover cable (basically your
PC). Now ping 192.168.0.100 to see if the connection was successful