
168
PQ-8P, PQ-8S
Appendix F: Transferring
Power to Pin 18
5. Locate the jumper in the lower
left corner, right above the
parallel connector labeled
“Parallel In From PC/LAN”
(see
Figure F-1)
.
6. Remove the black jumper from
the pin, then reinsert it covering
both pins (see
Figures F-1a
and
F1-b
).
7. Slide the PQ-8 board back into
the bottom groove of the chassis.
8. Tighten the black screws on the
back panel.
9. Connect the printer and the
PC/LAN to the PQ-8, then
connect the power cord.
10. Power on the printer, then the
PQ-8.
To transfer power to pin 18 of the
parallel input connector of the
PQ-8P, you must move a jumper on
the PQ-8P board. To move this
jumper do the following:
1. Power off the printer, the
PQ-8P, and the attached PC or
LAN print server.
2. Disconnect all cables from the
PQ-8P.
3. Remove the two black screws
from the outside of the back
panel.
4. Pull out the PQ-8P’s back panel,
together with the attached
board.
Figure F-1a.
Figure F-1b.
Figure F-1. Jumpers.