59
E.3 Connecting the Interface Driver Board
Included in your 10BASE-T Ethernet Bridge Module package is an interface driver
board that allows you to configure your front function card for Ethernet operation.
Figure E-2 shows the interface driver board connected to a ME0003C or ME0004C
front function card.
Figure E-2. Interface driver board mounted on a ME0003C or ME0004C
front card.
Follow the instructions below to connect the interface driver board to the front
function card.
1. With the function card pulled out of the Managed Micro Rack, locate the
driver board to be replaced on the top of the base unit front card.
2. Lift the old interface board gently off the printed circuit board.
3. Position the Interface Driver Board on top of the function card’s PC board
with the sockets oriented toward the male pins. Be sure that the label marked
FRONT
is pointed toward the front of the function card (toward the LEDs).
4. Push the Interface Driver Board gently onto the socket and re-install the
function card into the rack.
APPENDIX E: 10BASE-T Ethernet Bridge Module
Interface Driver Board
Front
Rear
10BASE-T
Ethernet Bridge
Module
