
46
CHAPTER 2: DECODERS
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
DEVICE SETTING
2ND LEVEL
3RD LEVEL
STATUS
TRANSCEIVER
USB CONTROL
MODE
HOST
DEVICE
USB VIRTUAL HUB
OFF
ON
HDMI OUT SOURCE
INPUT 1
(HDMI)
INPUT 2
(DP)
INPUT 3 (VOIP)
VOIP OUT SOURCE
INPUT 1 (HDMI)
INPUT 2
(DP)
INPUT 3
(VOIP)
HDMI OUT AUTO
MODE
OFF
AUTO SWITCH
VOIP OUT AUTO
MODE
OFF
AUTO SWITCH
FIGURE 2-12: DEVICE SETTING MENU
TABLE 2-6. DEVICE SETTINGS
SECOND LEVEL IN FIGURE 2-12 SELECTION
DESCRIPTION
STATUS
Transceiver
Displays the unit’s current operational mode.
NOTE: Due to this unit’s support of bi-directional transmission, the
status will always be set to “Transceiver.”
USB Control Mode
Multiple
Enable or disable the USB 2.0 (Mini-B) port for connection to USB host
devices, such as a PC or laptop. Selecting [Device] enables the USB 2.0
(Mini-B) port. Selecting
[Host]
disables the USB 2.0 (Mini-B) port.
NOTE: In a point-to-point extension configuration, only one of the two
transceivers should be set as a USB Device to avoid conflicts.
USB Virtual hub
Off/On
Enables or disables the “simultaneous connection” USB mode which
allows the PC/Laptop connected to this unit to be paired with the USB
devices on up to seven “Host” mode transceivers.
NOTE: Only available when USB Control Mode is set to “Device”.
USB routing can only be configured by use of the optional MCX
Gen2 Controller or control software and is not valid in point-to-point
configurations.
HDMI Out Source
Multiple
Select the input source to display on the HDMI output.
VOIP Out Source
Multiple
Select the input source to transmit as an AV over IP stream.
HDMI Out Auto Mode
Off/Auto Switch
Enable or disable the HDMI output’s automatic source selection mode.
When enabled, the unit will automatically switch the input routed to the
local HDMI output whenever a new source is detected or if the current
source is lost.
VOIP Out Auto Mode
Off/Auto Switch
Enable or disable the AVoIP streaming output’s automatic source
selection mode. When enabled, the unit will switch the input routed to the
AVoIP output whenever a new source is detected or if the current source
is lost.