12
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
INITIAL CONFIGURATION
Agility units are designed to be as flexible as possible and this principle extends also to their configuration.
DIRECT LINKING
Where Agility transmitters and receivers are directly linked to each other, very little configuration action is required, provided that
they have their factory default settings in place. If the standard settings have been changed in a previous installation, you merely
need to perform a factory reset on each unit.
NETWORKED LINKING
Where Agility units are connected via networked links, you can either configure them individually, or configure them collectively
using an IPATH Agility Controller:
•
Configuring networked Agility units individually
- You need to specify the network addresses of the Agility units so that they
can locate each other. This is done by running the
Browser-based configuration utility
on a computer system linked to the
same network as the Agility units.
•
Configuring Agility units collectively
- The iPATH Agility Controller allows you to configure, control and coordinate any number
of Agility transmitters and receivers from a single application.
• If you are using one or more Agility Zero U transmitters within an installation managed by an IPATH Agility Controller, the
IPATH Agility Controller must be running firmware version 4.12 or above.
IMPORTANT: When using IPATH to configure Agility units, it is vital that all units that you wish to locate and control are set to
their factory default settings. Otherwise they will not be located by the IPATH Agility Controller. If necessary, perform a factory
reset on each Agility unit.
MANUAL FACTORY RESET
A factory reset returns Agility Zero U unit to its default configuration. You can perform factory resets using the
or by using this direct manual method.
TO PERFORM A MANUAL FACTORY RESET
1 Power on the Agility Zero U unit.
2 Use a narrow implement (e.g. a straightened-out paper clip) to press-and-hold the recessed reset button on the front panel
for roughly fifteen seconds, until the indicators turn
blue
(Note: alternating red/green indications will occur during the fifteen
second period while the button is still pressed)
.
CHAPTER 4: CONFIGURATION
3 Release the reset switch.
The indicators will remain
blue
for a short while (less than ten seconds) while Agility Zero U unit configures itself and should
then change to
green
if all connections are correct; or
orange
if one or more of the video, USB and/or network links are missing.
NOTE: If you are performing a factory reset and intend to disconnect the power immediately after the reset, you must wait at least 30 seconds after
you have released the reset button for it to complete the process.
Use a straightened-out paper
clip to press the reset button
for roughly 5 seconds
WWW
.BLACKBOX.CO
M
WWW
.BLACKBOX.CO
M