7
• This product is intended for use in a
temperature range of 41°F(5°C) -
104°F(40°C).
CAUTION:
Use of controls or
adjustments or performance of
procedures other than those specified in
this manual may result in hazardous
laser radiation exposure.
The label on your tool may include the
following symbols.
V ................................volts
mW ............................milliwatts
nm..............................wavelength in
nanometers
IIa ..............................Class II Laser
The label on your tool may include the
following symbols.
V..............volts
A..............amperes
Hz............hertz
W ............watts
min ..........minutes
............alternating current
........direct current
no ............no load speed
............Class II Construction
…/min......revolutions or
................reciprocation per minute
............earthing terminal
............safety alert symbol
MOTOR
Be sure your power supply agrees with
nameplate marking. 120 Volts AC means
your tool will operate on standard 60 Hz
household power. Do not operate AC
tools on DC. A rating of 120 volts AC/DC
means that your tool will operate on
standard 60 Hz AC or DC power. This
information is printed on the nameplate.
Lower voltage will cause loss of power
and can result in over-heating. All
Black
& Decker
tools are factory-tested; if this
tool does not operate, check the power
supply. This tool is AC only.
ASSEMBLY / ADJUSTMENT
SET-UP
CUTTING DEPTH ADJUSTMENT
WARNING:
Always unplug saw from
power supply before any of the following
operations.
Adjust depth of cut using depth
adjustment knob as shown in
figure 5
for
proper setting. Tighten knob securely. Set
depth adjustment of saw such that one
tooth of the blade projects below the
workpiece as shown in
figure 6
.
5
Depth adjustment
knob
6
Tip of tooth
Surface of wood
Avoid
exposure-
Laser
radiation
emitted from
this
aperture.
8
633145-02,01 QP1020LK 12/16/05 1:20 PM Page 7
