ENGLISH
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
suitable for the wall type and is appropriate to the weight of
the appliance.
Mark the location of the screw holes (within reach of an
electrical outlet for charging the vac while it is on the wall
bracket).
Fix the mounting bracket to the wall using appropriate
screws and plugs for the type of wall and weight of the ap-
pliance.
Hang the appliance on the wall by placing the opening
on the base of the vac over the hooks in the wall mount
charging bracket.
These models may be supplied with some of the following
accessories:
A squeege tool (10) for wet use on hard surfaces.
A brush tool (11) for furniture and stairs.
Insert the appropriate accessory into the front of the appli-
ance. Make sure that the accessory is pushed fully in.
24 hours.
Place the appliance on the charging bracket whenever it is
not in use.
Before charging, be sure to empty all liquid contents
and dry thoroughly, to avoid damage to your appliance.
Make sure that the appliance is switched off. The battery
will not be charged with the on/off switch in the on posi-
tion.
Place the appliance on the charging bracket (5).
Plug in the charger. Switch on at the mains.
Leave the appliance to charge for at least 21 hours.
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
To switch the appliance on, slide the on/off switch (1)
forward to position 1.
To switch the appliance off, slide the on/off switch (1) back
to position 0.
For everyday spills of dry material.
For everyday spills of dry material, use your appliance
without the squeegee accessory.
Your product is designed for light spills only.
This appliance can also be used to pick up everyday liquid
spills. Use the squeegee accessory on non-absorbent,
hard surfaces. On absorbent surfaces, such as carpet,
your appliance will pick up wet spills better without the
accessory.
For best performance on hard surface wet pickups, insert
squeegee into the bowl nozzle opening.
For best results when using this accessory, hold the appli-
ance at an angle of 45° and pull it slowly towards you.
there is any liquid in the bowl, do not turn the unit upside
down, sideways, point the nozzle upward, or shake the
vac excessively.
After picking up liquid substances clean the appliance and
not properly cleaned after wet pickups.
Before charging, be sure to empty all liquid contents and
dry thoroughly, to avoid damage to your appliance.
cleared regularly during use.
regularly.
Press the bowl release button (2) and pull the dust bowl
(3) straight off.
While holding the dust bowl over a bin or sink, pull out the
To replace the dust bowl, place it back onto the handle
-
