ENGLISH
Use your Black & Decker charger only
to charge the battery in the appliance/
tool with which it was supplied. Other
batteries could burst, causing personal
injury and damage.
Never attempt to charge nonrecharge-
able batteries.
If the supply cord is damaged, it must
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be
placed in a well ventilated area when
charging.
Your charger has been designed
that the mains voltage corresponds
to the voltage on the rating plate.
Never attempt to replace the charg-
er unit with a regular mains plug.
Read all of this manual carefully
before using the appliance.
#
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
w
Short circuit proof safety isolat-
ing transformer. The mains sup-
ply is electrically separated from
the transformer output.
x
The charger automatically shuts
off if the ambient temperature
becomes too high. As a con-
sequence the charger will be
inoperable. The charging base
must be disconnected from the
mains supply and taken to an
authorised service centre for
repair.
$
The charging base is intended
for indoor use only.
This tool includes some or all of the following features.
1. On/off switch
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
6.
NV3620, NV4820 & NV4820C Only)
7.
NV4820 & NV4820C Only)
8. Wet/Dry foam insert (NW3620 & NW4820 Only)
9.
10. Squeegee (NW3620 & NW4820 Only)
11. Brush tool (NV2420, NV3620, NV4820 & NV4820C
Only)
12. Crevice tool (NV2420, NV3620, NV4820 &
NV4820C Only)
