5
ENGLISH
(Original instructions)
u
Never attempt to remove or replace
any parts other than those specified in
this manual.
Additional safety instruc-
tions
Residual risks.
Additional residual risks may arise
when using the tool which may not
be included in the enclosed safety
warnings. These risks can arise
from misuse, prolonged use etc.
Even with the application of the
relevant safety regulations and the
implementation of safety devices,
certain residual risks can not be
avoided. These include:
u
Injuries caused by touching any mov-
ing parts.
u
Injuries caused by touching any hot
parts.
u
Injuries caused when changing any
parts or accessories.
u
Injuries caused by prolonged use of
the appliance. When using any appli-
ance for prolonged periods ensure you
take regular breaks.
Batteries and chargers
Batteries
u
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the
temperature may exceed 40°C.
u
Charge only at ambient temperatures
between 10°C and 40°C.
u
Charge only using the charger pro-
vided with the appliance/tool. Using
the wrong charger could result in an
electric shock or overheating of the
battery.
u
When disposing of batteries, follow
the instructions given in the section
"Protecting the environment".
u
Do not damage/deform the battery
pack either by puncture or impact, as
this may create a risk of injury and fire.
u
Do not charge damaged batteries.
u
Under extreme conditions, battery
leakage may occur. When you notice
liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin
contact.
u
In case of skin or eye contact, follow
the instructions below.
Warning!
The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed
for a specific voltage. Always check
that the mains voltage corresponds
to the voltage on the rating plate
and the information in the technical
data table.
Warning!
Never attempt to replace
the charger unit with a regular mains
plug.
