READINg thE BAttERY/ChARgE StAtUS lED INDICAtOR
The battery and charging status LED indicator is located on the top of the unit. It lights or flashes in
three colors to indicate the following:
when charging:
Green: Battery is in a fully charged state.
Orange (flashing): Battery is in a partially charged state.
Red (flashing): Battery needs to be recharged.
when operating:
Green: Battery is operating at full voltage.
Orange: Battery is operating at partial voltage.
Red: Battery is operating at low voltage, and should be recharged.
ChARgINg/REChARgINg thE SPOtlIght
This unit is shipped in a partially charged state. Charge unit after purchase and BEFORE first use using
the 120 Volt AC Adapter for 12 hours.
Recharge after each use until the battery/charge status LED indicator lights green.
IMPORTANT: When the unit is not in use, we recommend that the battery is charged at least every
3 to 6 months.
Charging/recharging using the 120 Volt AC Adapter
• Make sure the spotlight is off (the trigger lock is in the off position and the trigger is not depressed).
• Insert the barrel connector of the AC Adapter into the AC to DC Charging Port on the back of the
unit. Insert the plug end into a (powered) standard North American 120 volt 60Hz outlet.
• Charge until the battery/charge status LED indicator lights green (approximately 12 hours).
Charging/recharging using the 12 Volt DC Adapter (optional accessory)
• Make sure the spotlight is off (the trigger lock is in the off position and the trigger is not depressed).
• Insert the barrel tip of the supplied 12 Volt DC Adapter into the 12 Volt DC Power and Charging Port
on the back of the unit.
• Insert the 12 volt DC plug end into the accessory outlet of your vehicle or other 12 volt DC power
source.
• Charge until the battery/charge status LED indicator lights green (approximately 12 hours).
Notes:
When using a vehicle’s 12 volt DC accessory outlet as a charging source, be aware that some vehicles require you to turn on the
ignition to power the accessory outlet.
WARNING:TO AVOID THE RISK OF PROPERTY DAMAGE:
•
NEVER CONNECT THE UNIT TO A POSITIVE GROUNDED VEHICLE.
• The 12 Volt DC Adapter must only be connected to batteries with a nominal output voltage of 12
volts. The unit will not operate from a 6 volt battery and will sustain permanent damage if connected
to a 24 volt battery.
oPERAting inStRuctionS
Operating the spotlight
1. Disconnect from charger.
2. The On/Off trigger is located in the front of the handle of the spotlight.
3. To turn the spotlight on, squeeze the trigger.
4. To turn off the spotlight, release the trigger.
Notes:
The On/Off trigger can be locked in the on position using the trigger lock bar on the side of the unit.
The battery/charge status LED indicator will light in one of three colors (as described in the “Reading the Battery/Charge Status LED
Indicator” section) to indicate the battery status.
locking the spotlight
To lock the spotlight in the on position, depress the On/Off Trigger, then press the trigger lock bar. The
spotlight will stay on until the trigger unlock bar is pressed and the On/Off Trigger is released.
If the On/Off Trigger is released when the trigger lock bar is pressed, the spotlight will be locked in
the off position. To turn the spotlight on again, press the trigger unlock bar before pressing the On/Off
Trigger.
Using the light mode select button
The spotlight offers two brightness modes.
When the spotlight is firstly turned on, the light is operating at maximum brightness. To operate the
spotlight at medium brightness, press the Light Mode Select Button on the back of unit once. Press it
again to switch back to maximum brightness.
Operating the unit corded
Plug the barrel tip of the supplied 12 volt DC adapter into the 12 volt DC power and charging port at
the back of the unit. Insert the plug end into the accessory outlet of your vehicle or other 12 volt DC
power source. Operate the unit as outlined in the previous section.
IMPORTANT: The spotlight will operate while the 120 Volt AC Adapter is attached, but will continue
to draw power from the unit’s Lithium-Ion battery and will not continue charging while the spotlight
operates. Manufacturer recommends only operating the unit in corded mode using the 12 Volt DC
Adapter.
Using the Swing-up Stand
Snap the Swing-up Stand up, invert the unit and set it upon a flat, stable surface for hands-free
operation.
Using the carry lanyard (optional accessory)
The carry lanyard may be used to carry the unit or to hang it for storage. Always adjust the slide on
the cords to keep the lanyard secure around any supporting object.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When light is hung by the carry lanyard, do not shake the spotlight or object that it is hanging from.
Do not hang the spotlight from any electrical wires or anything that it is not secure.
• Only use the carry lanyard for hanging this spotlight. The carry lanyard is not intended to support
additional weight. Do not attach or hang anything additional to the spotlight or risk of breakage may
occur.
CARE AND MAINtENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When
the unit is not in use, we recommend that the battery is charged at least every 3 to 6 months.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit
with a soft cloth moistened with a mild solution of water and detergent.
Except for the H3, 40 watt bulb, there are no user-replaceable parts. Periodically inspect the condition
of adapters, connectors and wires. Contact manufacturer to replace any components that have become
worn or broken.
Battery replacement/disposal
BATTERy REPLACEMENT
The battery should last the service life of the unit. Contact manufacturer for any information you may
need.
SAFE BATTERy DISPOSAL
Contains a lithium-ion battery, which must be disposed of properly. Recycling is required, contact your
local authority for information. Failure to comply with local, state and federal regulations can result in
fines, or imprisonment.
Contact your local waste management authority to dispose of this product.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
PLEASE
RECYCLE
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent
shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
Spotlight Bulb Replacement
To replace the bulb, you will need a small Phillips screwdriver and a 9 volt, H3 40 watt replacement
bulb. During installation, avoid touching the glass part of the bulb. Bulb life may be shortened by
installing a bulb with dirt or fingerprints on it. The bulb can be wiped clean with a cloth moistened
with alcohol.
