37
When the waveform generator finishes the diagnostic self-test routine, it enters the local state (LOGS)
and assumes power-on default settings. Table 1 lists the factory default settings or selected after
RECALL 0.
Table 1 – Power-on Default Settings
Key Function
Value
Description
Function
Sine
Output Waveform
Frequency
1.0000 kHz
Waveform Frequency
Amplitude
5.00 V
Peak-to-peak output amplitude
Offset
0.00 V
Zero DC offset
Output
OFF
Output disabled
Sweep
OFF
Sweep function disabled
Modulation
OFF
Modulation function disabled
N-BURST
2
Wave per burst for burst mode
Trig Source
Continuous
Continuous trigger
Trig Rate
10 ms
Internal trigger rate
3.6 Memory
The waveform generator uses non-volatile flash memory for storing the front panel settings.
Up to 20 front panel settings can be stored (includes storage location 0 for factory default settings).
One 16382-point arbitrary waveform is stored in the flash non-volatile memory.
3.7 Displaying Errors
The waveform generator displays error messages when front-panel settings are either invalid or may
produce unexpected results.
Table 2 – Error Messages
Message Text
Description
Out of range
The set value is out of the instrument’s limits.
Setting conflict
Settings conflict with another parameter setting or value.
Empty location
Attempt to recall settings from an empty storage location.
Trig rate short
Internal trigger rate is too short to output waveform or burst.
Save RAM
New firmware installed.
Must divide by 4
Predefined wave length must be divisible by 4.
Must divide by 2
Predefined wave length must be divisible by 2.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
