BITREK BI-530C TREK, Руководство по эксплуатации

Страница: 14 / 59

14
www.bitrek.eu
sales@bitrek.eu
+372 880 78 78
Example of response:
“Param ID 0242 New Val: gps.utel.ua».
Update of device software.
Command to be send – BOOT #,#,#;
Example of command to update the software:
« BOOT fw.bitrek.ua ,80,*.bin; »
, where:
«HOST» - (fw.bitrek.ua,) is address of server locating the update files;
« PORT» – (80,) – port of server locating the update files;
«Firmware» - (*.bin;) – binary update file,
where * is the firmware version, .bin is the file
extension.
This command allows remote software update of the device via GPRS
channel.
Note: Enable “download” for the SIM-card, and set the session timeout
not less than 10 seconds.
There are following responses at attempt to update the device software:
«BOOT: UPDATE DOWNLOAD OK
»
- successful update;
«BOOT: WAITE ERROR» – exceeded timeout at downloading software
update;
«BOOT: HOST CONNECT ERROR» – failure to connect to SW server;
«BOOT: PAGE LOAD ERROR» – failure to load the file;
«BOOT: UPDATE DOWNLOAD ERROR» – failure to update the file.
Set the mode of operation of digital output Out 1.
Command to be send – setdigout #;
Example of command for the activation of the output Out 1: setdigout 1;
When it is necessary to activate the output, set the output value must to
“1”. When it is necessary to deactivate the output, set the value to “0”.
Activate/deactivate the safety locking of ignition.
Command to activate safe locking – ignitionon;
Command to deactivate safe locking – ignitionoff;
In case of activation of secure locking the discrete output Out 1 will be
activated if the speed according to GPS is less than 5 km/h.
Examples of response:
«Set RQS To Ignition On» - ignition switch on;
«Set RQS To Ignition Off» - ignition switch off;