BT-740 Operation manual
32
P/N : 740-ENG-OPM-EUR-D03
Bistos Co., Ltd.
2018.05
3
Basic operations
3.1 Turn on
3.1.1 Check the monitor
-
Before turn on the monitor, check whether there is mechanical damage to the monitor,
and whether the external cables and accessories are connected correctly.
-
Plug the power adapter into the AC power outlet. If using battery power, make sure the
battery is fully charged.
-
Check all the functions required for patient monitoring to make sure that the monitor
operates properly.
WARNING
If the monitor is damaged, or fails to work normally, do not use it for patient
monitoring. Please contact the maintenance personnel or Bistos immediately.
3.1.2 Start the monitor
If finish to check the monitor, it is ready to start the monitor.
Press the [Power] key, the yellow warning lights flash once and the system enter the
program reading interface; finally the system makes a “tick” sound, the boot screen disappears,
and the system enters the main interface.
-
If any fatal error occurs during self-test, the system will alarm. If this case persists,
please stop to using the monitor and contact the maintenance personnel or Bistos.
-
Check all available monitor functions to ensure that the monitor operate properly.
-
If the monitor equipped with a battery, charge the battery after each use to ensure
sufficient power.
-
After unpacking, when use the monitor first time, the monitor should be powered
with adapter.
3.1.3 Connect the sensors
Connect the required sensor to the monitor and the monitoring site of patient.
